‹ Training
TJS Training · Installing Fire Lines

Flush & test

Lesson 9 of 9About 5 minutes
  1. 1Prep & layout
  2. 2Stations
  3. 3Tie-in to the city main
  4. 4Detector check
  5. 5Bed & lay
  6. 6Fittings & restraint
  7. 7Fire riser
  8. 8Cover it right
  9. 9Flush & test

Watch

Main to riser, from the side
Building City main

The steps

The flush and the test are where the inspector decides if the line is done. Trash left in the line ends up in the sprinkler heads. A test that drops means digging up what we just covered.

  1. Ready. All restraint on, thrust blocks cured, and the witness scheduled through the GC. The fire marshal usually watches the flush and the test.
  2. Flush with the main, before the sprinkler company ties on. Open the valve slowly.
  3. Enough flow: NFPA calls for 10 ft per second through the pipe. That is 390 gpm on 4 inch, 880 gpm on 6 inch, 1,560 gpm on 8 inch. The inspector decides if the flush is good enough.
  4. Hoses on the test tee. Our test tee has 2 inch cam locks. Tie the hoses down so they can't whip, and point them where the water won't wash out the site.
  5. Until it runs clear. There is no set time. Clear water is the finish line.
  6. Close the tee valves and pump it up. The blind flange never comes off: the test tee has the pump connection and the valves. Fill slowly and bleed the air.
  7. Hydro: 200 psi for 2 hours, or 50 psi over the static pressure if that is higher. The gauge does not drop. If it drops, find the leak. Don't pump it back up and call it good.
  8. Test certificate signed by the witness.
  9. Photos: the flush running clear, and the gauge at the start and the end of the 2 hours with the time showing.

Your photos

In TJS Field

Three photos on every test.

  1. Open TJS Field.
  2. Pick the job.
  3. Tap the camera button, 📷 Take a photo, and take the picture.
  4. Tag it Test / inspection.

Photo 1, the flush

  • The water running clear

Photos 2 and 3, the gauge

  • At the start: 200 psi and the time
  • At the end, 2 hours later: still 200 psi and the time

Then photo the signed test certificate.

Check

3 questions · get all 3