‹ Training
TJS Training · Installing Fire Lines

Fire riser

Lesson 7 of 9About 4 minutes
  1. 1Prep & layout
  2. 2Stations
  3. 3Tie-in to the city main
  4. 4Detector check
  5. 5Bed & lay
  6. 6Fittings & restraint
  7. 7Fire riser
  8. 8Cover it right
  9. 9Flush & test

Watch

The building edge, from the side
Outside grade Footing Finished floor

The steps

The riser is where our work ends and the sprinkler company's starts. In the wrong spot, at the wrong height or out of plumb, it is the first thing they find and the hardest thing for us to fix once the slab is poured.

  1. Locate it exactly. Use the plans, and Rob measures from the slab to put the riser exactly where the plans show it. Confirm with the GC.
  2. Under the footing, not through it, unless the plans show a sleeve. Bed around the pipe so the footing doesn't sit on it.
  3. Stainless steel riser: its inlet usually sticks out past the footing, and the bell gets a bell joint restraint.
  4. Custom ductile riser: a Megalug on the PVC into the DI 90. All-thread and duc lugs from the top of the 90 to the MJ x flange adapter.
  5. Thrust block behind the 90, against undisturbed soil. Both risers get one, stainless and ductile.
  6. Exactly plumb and level. Not close: exact. Level on two faces of the riser and across the flange, bubble dead center. Then brace it so the slab pour can't move it.
  7. 18 inches above finished floor to the flange, unless the GC or the sprinkler company say otherwise.
  8. Blind flange on top to keep dirt out and hold the test.
  9. Poly wrap the whole thing.
  10. Photos: the base before backfill, the riser plumb with the level on it, and the riser wrapped.

Your photos

In TJS Field

Three photos of every riser.

  1. Open TJS Field.
  2. Pick the job.
  3. Tap the camera button, 📷 Take a photo, and take the picture.
  4. Tag it Fitting / valve.

Photo 1, before backfill

  • The 90 and its restraint: the bell joint restraint, or the Megalug and all-thread
  • The thrust block

Photo 2, plumb

  • The level on the riser, bubble dead center
  • The tape showing the height

Photo 3, wrapped

  • The poly wrap on all of it

Check

3 questions · get all 3